Raw 16-bit registers from a DGA monitor or PLC can represent 32-bit integers and IEEE-754 floats in several different byte orders. This decoder shows every common interpretation side by side, so you can match a register map without guesswork.

What the decoder does

Enter two or four holding registers as hexadecimal or decimal 16-bit words. The decoder returns:

  • 16-bit values — UINT16 and INT16 for each register, including the byte-swapped variant.
  • 32-bit values — INT32 and UINT32 for the selected byte order.
  • FLOAT32 — the IEEE-754 single-precision value, if the bit pattern is a normal number.
  • All four byte orders — ABCD, BADC, CDAB and DCBA, shown together so a mismatch is obvious.

The tool runs entirely in your browser. Registers are not sent to a server.

How access works

Enter your work email. We validate the address and send a signed access link immediately. The same link is shown on this page after you submit. It stays valid for 30 days.

Get the decoder

Already have an access link? Open the decoder — it stays valid for 30 days.

We use the address only to send the link and occasional technical updates. You can ask us to delete it at any time.

The decoder is a configuration aid. Always verify a register map against the device manual before writing values to a live system. PAS DGA · Shenzhen Feso Automation Technology Co., Ltd. · sales@pasdga.com · +86 132 6572 6720