Enter raw 16-bit holding registers from a DGA monitor, PLC or SCADA gateway. The decoder shows the 16-bit, 32-bit and IEEE-754 float interpretation under every common byte order. Decoding runs in your browser; register values are not sent anywhere.
16-bit values
| Register | UINT16 | INT16 | Byte-swapped UINT16 |
|---|
32-bit values — all byte orders
| Byte order | Word | INT32 | UINT32 | FLOAT32 | Hex |
|---|
ABCD = big-endian (high word first). CDAB = little-endian word swap with big-endian bytes. BADC and DCBA swap bytes inside each word. FLOAT32 is shown only when the bit pattern is a finite number.
What the byte order means
Most Modbus devices transmit the high word first, but the order of the two bytes inside each word, and the order of the words themselves, is device-specific. If a decoded flow reads as a tiny value near zero or an absurd number, the byte order is wrong. Match the value against the device manual or a known reading before trusting the bit pattern.